| /* |
| * Fill Window with SSE2-optimized hash shifting |
| * |
| * Copyright (C) 2013 Intel Corporation |
| * Authors: |
| * Arjan van de Ven <arjan@linux.intel.com> |
| * Jim Kukunas <james.t.kukunas@linux.intel.com> |
| * |
| * For conditions of distribution and use, see copyright notice in zlib.h |
| */ |
| |
| #include <immintrin.h> |
| #include "deflate.h" |
| |
| #define UPDATE_HASH(s,h,i) \ |
| {\ |
| if (s->level < 6) { \ |
| h = (3483 * (s->window[i]) +\ |
| 23081* (s->window[i+1]) +\ |
| 6954 * (s->window[i+2]) +\ |
| 20947* (s->window[i+3])) & s->hash_mask;\ |
| } else {\ |
| h = (25881* (s->window[i]) +\ |
| 24674* (s->window[i+1]) +\ |
| 25811* (s->window[i+2])) & s->hash_mask;\ |
| }\ |
| }\ |
| |
| extern int deflate_read_buf OF((z_streamp strm, Bytef *buf, unsigned size)); |
| |
| void fill_window_sse(deflate_state *s) |
| { |
| const __m128i xmm_wsize = _mm_set1_epi16(s->w_size); |
| |
| register unsigned n; |
| register Posf *p; |
| unsigned more; /* Amount of free space at the end of the window. */ |
| uInt wsize = s->w_size; |
| |
| Assert(s->lookahead < MIN_LOOKAHEAD, "already enough lookahead"); |
| |
| do { |
| more = (unsigned)(s->window_size -(ulg)s->lookahead -(ulg)s->strstart); |
| |
| /* Deal with !@#$% 64K limit: */ |
| if (sizeof(int) <= 2) { |
| if (more == 0 && s->strstart == 0 && s->lookahead == 0) { |
| more = wsize; |
| |
| } else if (more == (unsigned)(-1)) { |
| /* Very unlikely, but possible on 16 bit machine if |
| * strstart == 0 && lookahead == 1 (input done a byte at time) |
| */ |
| more--; |
| } |
| } |
| |
| /* If the window is almost full and there is insufficient lookahead, |
| * move the upper half to the lower one to make room in the upper half. |
| */ |
| if (s->strstart >= wsize+MAX_DIST(s)) { |
| |
| zmemcpy(s->window, s->window+wsize, (unsigned)wsize); |
| s->match_start -= wsize; |
| s->strstart -= wsize; /* we now have strstart >= MAX_DIST */ |
| s->block_start -= (long) wsize; |
| |
| /* Slide the hash table (could be avoided with 32 bit values |
| at the expense of memory usage). We slide even when level == 0 |
| to keep the hash table consistent if we switch back to level > 0 |
| later. (Using level 0 permanently is not an optimal usage of |
| zlib, so we don't care about this pathological case.) |
| */ |
| n = s->hash_size; |
| p = &s->head[n]; |
| p -= 8; |
| do { |
| __m128i value, result; |
| |
| value = _mm_loadu_si128((__m128i *)p); |
| result = _mm_subs_epu16(value, xmm_wsize); |
| _mm_storeu_si128((__m128i *)p, result); |
| |
| p -= 8; |
| n -= 8; |
| } while (n > 0); |
| |
| n = wsize; |
| #ifndef FASTEST |
| p = &s->prev[n]; |
| p -= 8; |
| do { |
| __m128i value, result; |
| |
| value = _mm_loadu_si128((__m128i *)p); |
| result = _mm_subs_epu16(value, xmm_wsize); |
| _mm_storeu_si128((__m128i *)p, result); |
| |
| p -= 8; |
| n -= 8; |
| } while (n > 0); |
| #endif |
| more += wsize; |
| } |
| if (s->strm->avail_in == 0) break; |
| |
| /* If there was no sliding: |
| * strstart <= WSIZE+MAX_DIST-1 && lookahead <= MIN_LOOKAHEAD - 1 && |
| * more == window_size - lookahead - strstart |
| * => more >= window_size - (MIN_LOOKAHEAD-1 + WSIZE + MAX_DIST-1) |
| * => more >= window_size - 2*WSIZE + 2 |
| * In the BIG_MEM or MMAP case (not yet supported), |
| * window_size == input_size + MIN_LOOKAHEAD && |
| * strstart + s->lookahead <= input_size => more >= MIN_LOOKAHEAD. |
| * Otherwise, window_size == 2*WSIZE so more >= 2. |
| * If there was sliding, more >= WSIZE. So in all cases, more >= 2. |
| */ |
| Assert(more >= 2, "more < 2"); |
| |
| n = deflate_read_buf(s->strm, |
| s->window + s->strstart + s->lookahead, |
| more); |
| s->lookahead += n; |
| |
| /* Initialize the hash value now that we have some input: */ |
| if (s->lookahead >= MIN_MATCH) { |
| uInt str = s->strstart; |
| s->ins_h = s->window[str]; |
| if (str >= 1) |
| UPDATE_HASH(s, s->ins_h, str + 1 - (MIN_MATCH-1)); |
| #if MIN_MATCH != 3 |
| Call UPDATE_HASH() MIN_MATCH-3 more times |
| #endif |
| } |
| /* If the whole input has less than MIN_MATCH bytes, ins_h is garbage, |
| * but this is not important since only literal bytes will be emitted. |
| */ |
| |
| } while (s->lookahead < MIN_LOOKAHEAD && s->strm->avail_in != 0); |
| |
| /* If the WIN_INIT bytes after the end of the current data have never been |
| * written, then zero those bytes in order to avoid memory check reports of |
| * the use of uninitialized (or uninitialised as Julian writes) bytes by |
| * the longest match routines. Update the high water mark for the next |
| * time through here. WIN_INIT is set to MAX_MATCH since the longest match |
| * routines allow scanning to strstart + MAX_MATCH, ignoring lookahead. |
| */ |
| if (s->high_water < s->window_size) { |
| ulg curr = s->strstart + (ulg)(s->lookahead); |
| ulg init; |
| |
| if (s->high_water < curr) { |
| /* Previous high water mark below current data -- zero WIN_INIT |
| * bytes or up to end of window, whichever is less. |
| */ |
| init = s->window_size - curr; |
| if (init > WIN_INIT) |
| init = WIN_INIT; |
| zmemzero(s->window + curr, (unsigned)init); |
| s->high_water = curr + init; |
| } |
| else if (s->high_water < (ulg)curr + WIN_INIT) { |
| /* High water mark at or above current data, but below current data |
| * plus WIN_INIT -- zero out to current data plus WIN_INIT, or up |
| * to end of window, whichever is less. |
| */ |
| init = (ulg)curr + WIN_INIT - s->high_water; |
| if (init > s->window_size - s->high_water) |
| init = s->window_size - s->high_water; |
| zmemzero(s->window + s->high_water, (unsigned)init); |
| s->high_water += init; |
| } |
| } |
| |
| Assert((ulg)s->strstart <= s->window_size - MIN_LOOKAHEAD, |
| "not enough room for search"); |
| } |